5.5 Inch Long Arm Lift Kit W/Remote Reservoir Shocks 97-02 Wrangler TJ Stg 2 X Factor 12 Stretch Rock Krawler

5.5 Inch Long Arm Lift Kit W/Remote Reservoir Shocks 97-02 Wrangler TJ Stg 2 X Factor 12 Stretch from Rock Krawler.
System Benefits:
Excellent Highway Ride and Handling
102 Inch Wheel Base (8 Inch Rear Stretch)
High Clearance Lower Control Arms
Long Travel Functional Multi Rate Coil Springs
Sport Tuned 2.0 RRD Spec'd Prodigy Remote Reservoir Shocks
Independent Front 3 Link Design
Triangulated Rear 4 Link Design
Pro Front Sway Bar Disconnects
Allows for up to 35 Inch Tires w/ OEM Fenders
Allows for up to 37 Inch Tires w/ Flat Fenders
Allows for up to 38 Inch/40 Inch Tires w/ High Line Fenders
Abuse Proof Lifetime Warranty on all Hard Parts
Upgradeable to Coil Overs
System Includes:
(2) Long travel functional multi rate coil springs
(2) 2.0 RRD Spec'd Prodigy shocks
(4) High misalignment/adjustable lower long arms
(1) Adjustable front upper control arm
(1) High misalignment/adjustable front track bar
(2) Front adjustable sway bar disconnects
(2) Front sway bar link straps
(1) Skid plate and skid plate mounting brackets
(2) Rear upper triangulated 4 link arms
(1) Rear triangulated 4 link mounting cradle/axle truss
(1) Front track bar relocation bracket
(1) Drop pitman arm
(3) Extended stainless steel brake lines
(4) Bump stops
includes hardware and detailed instructions.
NOTES!
1. Available for most common axle combinations (Dana 30, 44, 60, Ford 8.8, Dynatrac ProRoc's). Can be adapted to fit Currie Rock Jock 60's and Solid 60's by rotating the rear cradle into the proper position instead of using the alignment tool provided.
2. Requires a SYE with C.V. Driveshaft.
3. With long rear uppers, a custom cat back exhaust is required.
4. Rubicon Edition TJ's require a new rear driveshaft.
5. 2003 TJ's equipped with 4 speed automatics will require removal of the factory automatic transmission skid plate if so equipped to allow for proper front driveshaft travel.
6. Requires removal of the OEM rear upper control arm mounts off the rear axle.
7. Requires cutting of the rear quarter panels to allow clearance for the new rear axle position.
8. Recommend using an OEM TJ rear coil when repositioning the rear spring bucket on the frame as shown in the directions.
9. Requires the use of a fuel cell mounted in the bed of the vehicle.